Open now: Mon–Fri · 7:30 AM – 4:30 PMLicensed Contractor · FGWA Member24/7 Answering Service(863) 965-2881

← Back to Blog

Why does my well pump keep running nonstop?

Why does my well pump keep running nonstop?

A well pump keeps running nonstop when the system is losing pressure, the pump is oversized or mis-set, a component is leaking, or the well itself cannot recover water fast enough, and the fix usually starts with a proper pump and pressure check.

Common reasons a well pump runs nonstop

When a pump should shut off but keeps cycling or never stops, the problem is usually in one of a few places: the pump, the pressure tank, the pressure switch, the plumbing, or the well. In Central Florida, we also see water-level and irrigation-demand issues that can make the problem look like a pump failure when it is really a system balance problem.

The most common causes include:

  • Water leak in the plumbing system
    A hidden leak lets pressure drop, so the pump keeps trying to recover it.

  • Failed or waterlogged pressure tank
    If the tank cannot hold air charge properly, the pump may run far longer than normal.

  • Bad pressure switch or control setting
    A worn switch can stick, fail to open, or misread pressure.

  • Check valve trouble
    A failed check valve can allow water to drain back, causing the system to keep trying to repressurize.

  • Pump unable to reach shutoff pressure
    Wear, a bad impeller, or an electrical problem can keep the pump from building enough pressure.

  • Well recovery problem
    If the well cannot supply water fast enough, the pump may run continuously trying to keep up.

If you are hearing the pump run longer than usual, do not keep resetting it over and over. That can turn a small repair into a bigger one.

What to check before the pump runs dry

A few symptoms help narrow the cause. If the pump runs nonstop only when no water is being used, that points toward a leak, tank, switch, or valve issue. If it runs nonstop only during heavy irrigation or high household demand, the system may be undersized or the well may be struggling to recover.

Look for these warning signs:

  • Low water pressure at faucets or sprinklers
  • Pump runs but pressure never reaches normal cut-off
  • Air spurting from fixtures
  • Waterlogged pressure tank symptoms
  • Visible wet spots, soft ground, or unexplained water use
  • Pump short-cycling before it eventually keeps running
  • Changes after lightning, power issues, or recent plumbing work

If the issue started after a storm, lightning damage can affect the pump, motor, pressure switch, or controls. We repair lightning-related well system problems and work directly with your insurance company on the claim when that is the cause.

For homeowners who need broader system service, our Pump Repair & Installation service covers pressure tanks, residential pumps, and the common pump types we rebuild in-house in our full-line machine shop.

Why this happens in Central Florida wells

Water level, geology, and demand

Central Florida wells can behave differently depending on local water table conditions and how the system is built. A shallow irrigation well that works well for one property may not perform the same on another site with a different water level or seasonal demand.

That is one reason we start with the full system, not just the pump. We evaluate whether the problem is the pump itself, the pressure equipment, the well depth and recovery, or the way the system is being used.

If your main issue is irrigation, our Shallow (2-Inch) Irrigation Wells page covers the kind of shallow well work that often makes sense for regular watering needs. If your pump is tied to sprinklers, the Irrigation Repair & Installation service may be the right path when valves, heads, controllers, or pump issues are involved.

Pressure tank or switch problems

A failing pressure tank is one of the most common reasons a well pump seems like it is never shutting off. When the tank loses its air charge or the internal bladder fails, the system cannot store pressure properly, so the pump keeps trying to refill it.

A bad pressure switch can create the same effect. If the switch does not open at the correct cut-off pressure, the pump may keep running even though the rest of the system is fine.

These are not DIY electrical jobs. If you suspect the tank or switch is involved, call for service rather than guessing at the wiring or settings.

When nonstop pumping points to the well, not just the equipment

Sometimes the pump is doing exactly what it can, but the well is the real issue. If the water level is too low, the pump may run continuously while producing very little pressure or flow. That can happen during dry periods, after increased irrigation use, or when a well is simply not sized for the current demand.

A few situations are especially common:

  • A shallow well that no longer matches the property’s demand
  • A deep well with worn components
  • A pump that is too small or too large for the system
  • A well that needs a site-specific evaluation and repiping

If the system is failing because the well is no longer the right fit, water well drilling may be the better long-term fix. Our Water Well Drilling service includes new well drilling for residential, agricultural, and commercial properties across Central Florida, along with site evaluation and casing selection.

Why call Dunham for a pump that won’t shut off

We have been drilling and servicing wells since 1950, and we know how to separate a pump problem from a pressure tank, switch, irrigation, or well issue. We also rebuild pumps and turbines in-house in our full-line machine shop, and we carry Goulds, Sta-Rite, Grundfos, and Schaefer new and used.

That matters when a system is running nonstop because the fix is not always a simple parts swap. Sometimes it takes testing, rebuild work, or a better system match for the property.

If you need help with a well pump keeps running nonstop problem in Polk County or Central Florida, call Dunham Well Drilling at (863) 965-2881 during business hours or use our 24/7 answering service after hours. We are a licensed water well drilling contractor, an FGWA member, and we have the experience to track down the cause instead of guessing.

Have a well or pump question?

Skip the form and call us. Our 24/7 answering service is always live.

Call (863) 965-2881
Call (863) 965-2881